RedMax HEZ3001S - Manual (Page 40)

40
Maintenance, replacement, or repair of the emission control device and systems may be performed by any
non-road engine repair establishment or individual.
• Always be sure to stop the engine before inspecting the stick edger for problems or performing
maintenance.
• Never alter the stick edger or take the engine apart.
• When replacing parts, always be sure to use only RedMax products or products which have been
certified by RedMax for use with the RedMax stick edger.
■ BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER
WARNING
9. Maintenance
English
Item to be checked Response
1 Edging mechanism • See if attachment is loose • Tighten screws and bolts
• Check if edges of blades are dull • Sharpen or replace blades
2 Throttle • Stiff and difficult to move • Repair or replace
3 Throttle wire • Too loose, too tight • Adjust
• Stiff and difficult to move • Repair or replace
4 Engine attachment • See if fittings are loose • Tighten fittings
5 Fuel tank • See if attachment is loose • Tighten screws and bolts
• See if fuel pipe is damaged • Replace
• See if cap packing is damaged • Replace
6 Muffler • See if attachment is loose • Tighten screws and bolts
7 Cutting blade • See if damaged or worn shorter than usable • Replace
length