Roland Fantom-X7 - Manual (Page 27)

27
Overview of the Fantom-X
LFO (Low Frequency Oscillator)
Use the LFO to create cyclic changes (modulation) in a sound. The
Fantom-X has two LFOs. You can use the LFO to apply an effect to
either the WG (pitch), the TVF (filter), or the TVA (volume). When an
LFO is applied to the WG pitch, a vibrato effect is produced. When an
LFO is applied to the TVF cutoff frequency, a wah effect is produced.
When an LFO is applied to the TVA volume, a tremolo effect is
produced.
LFO is not included in the rhythm tones (percussion instrument sounds).
Patches
Patches are the basic sound configurations that you play during a
performance. Each patch can be configured by combining up to four
tones. How the four tones are combined is determined by the
Structure Type parameter (p. 63).
fig.04-003.e
Rhythm Sets
Rhythm sets are groups of a number of different percussion
instrument sounds. Since percussion instruments generally do not
play melodies, there is no need for a percussion instrument sound to
be able to play a scale on the keyboard. It is, however, more
important that as many percussion instruments as possible be
available to you at the same time. Therefore, each key (note number)
of a rhythm set will produce a different percussion instrument.
fig.04-004.e
Each percussion instrument consists of the following four elements.
(For details, refer to the explanations for “Tones.”)
WG (Wave Generator): 1–4
TVF (Time Variant Filter)
TVA (Time Variant Amplifier)
Envelope
Performances
A performance has a patch or rhythm set assigned to each of the 16
parts, and can simultaneously handle 16 sounds.
The Fantom-X has two screens: a Layer screen and a Mixer screen (p.
100, p. 103).
Use the Layer screen if you want to play two or more patches
together (Layer) or play different patches in separate areas of the
keyboard (Split).
Use the Mixer screen if you want to “mix” by individually adjusting
the pan and level settings for each of the sixteen parts.
Because the Fantom sound generator can control multiple sounds
(instruments) it is called a Multi-timbral sound generator.
fig.04-005.e
Part
On the Fantom-X, a “part” is something to which you assign a patch
or rhythm set. Patch mode has two parts, the Pad part and the
Keyboard part, and you can assign a patch or rhythm set to each of
these parts. In Performance mode, each performance has sixteen
parts, and you can assign a patch or rhythm set to each part.
Patch
Tone 4
Tone 3
Tone 2
Tone 1
WG
Pitch
Envelope
TVF
TVF
Envelope
TVA
Envelope
TVA
LFO 1 LFO 2
Note Number 98 (D7)
Note Number 97 (C#7)
Note Number 36 (C2)
Note Number 35 (B1)
Rhythm Tone (Percussion instrument sound)
Rhythm Set
WG
Pitch
Envelope
TVF
TVF
Envelope
TVA
Envelope
TVA
Performance
Part 16
Part 1
Patch/
Rhythm Set
Layer
Mixer
Fantom-X678_r_e.book 27 ページ ２００５年５月１２日 木曜日 午後４時４０分