Value will raise the sensitivity (p. 46), 46 system settings – Roland Prelude User Manual

Page 46

Advertising
background image

46

System Settings

Pedal
Assign

FILL UP

The pedal will trigger a fill-in, and
then the next variation will play
(e.g., from MAIN “1” to “2”). Once
you reach variation “4,” subsequent
presses of the pedal will not change
the variation any farther.

FILL
DOWN

The pedal will trigger a fill-in, and
then the previous variation will play
(e.g., from MAIN “4” to “3”). Once
you reach variation “1,” subsequent
presses of the pedal will not change
the variation any farther.

PERFORM
UP

The pedal will switch to the next
Performance (i.e., from PERFORM
001 to 002).

PERFORM
DOWN

The pedal will switch to the previous
Performance (i.e., from PERFORM
002 to 001).

Pedal
Polarity

STANDARD,
REVERSE

Switches the polarity of the pedal
connected to the CONTROL PEDAL
jack. Some pedals will operate in the
opposite of the expected way when
you press them. If you’re using this
type of pedal, set this parameter to
“REVERSE.” If you’re using a Roland
pedal (without a polarity switch), use
“STANDARD.”

Hold
Polarity

STANDARD,
REVERSE

Switches the polarity of the pedal
connected to the HOLD PEDAL jack.
(See “Pedal Polarity,” above)

SYSTEM D BEAM

Parameter

Value

Explanation

D Beam
Sens

0–127

This sets the D Beam controller’s
sensitivity. The higher the value set,
the more readily the D Beam
controller goes to into erect.

D Beam
Filter/As-
signable 1

Refer to “Functions that can be assigned” (p. 34).

D Beam
Volume/
Assign-
able 2

SYSTEM MIDI

Parameter

Value

Explanation

MIDI Tx
Switch

OFF, ON

Refer to “MIDI Parameters” (p. 43).

Upper Tx
Channel

1–16

Lower Tx
Channel

1–16

MIDI Rx
Switch

OFF, ON

Upper Rx
Channel

1–16

Lower Rx
Channel

1–16

Tx

Tx Pitch
Bend

OFF, ON

Refer to “MIDI Parameters” (p. 43).

Tx
Modulation

OFF, ON

Tx
Program
Change

OFF, ON

Tx Clock

OFF, ON

Tx Start-
Stop

OFF, ON

Tx Song
Position

OFF, ON

Rx

Rx Sync

OFF, ON

Refer to “MIDI Parameters” (p. 43).

Rx Pitch
Bend

OFF, ON

Rx
Modulation

OFF, ON

Rx
Program
Change

OFF, ON

SYSTEM METRONOME

Parameter

Value

Explanation

Metronome
Switch*

OFF, ON

Refer to “Using the Metronome” (p.
22).

Metronome
Mode

ALWAYS,
REC, PLAY

Metronome
Level

LOW,
MEDIUM,
HIGH

Prelude_e.book Page 46 Wednesday, January 14, 2009 2:18 PM

Advertising