Renesas Emulation Pod M3062PT3-RPD-E - Manual (Page 18)

M3062PT3-RPD-E User’s Manual 1. Outline
REJ10J0040-0600 Rev.6.00 July 01, 2006 Page 18 of 104
1.4 Specifications
Tables 1.5 and 1.6 list the specifications of the M3062PT3-RPD-E.
Table 1.5 M3062PT3-RPD-E specifications (1/2)
Item Description
Applicable MCU
M16C/60 Series M16C/62P Group
M16C/30 Series M16C/30P Group
Usable MCU mode
Single-chip mode
Memory expansion mode
Microprocessor mode
Maximum operating frequency 16MHz
Applicable power supply 2.7 to 5.5V
Internal ROM/RAM capacity : 0 wait, 16MHz(max)
: 0 wait, 8MHz(max)
Emulation Memory 1MB
External area
: 1 wait,16MHz(max)
Main clock
Internal oscillator circuit board (OSC-3)
Switchable to external oscillator input
Clock supply
Sub clock
Internal oscillator circuit (fixed 32.768kHz)
Switchable to external oscillator input
Basic debugging functions
- Download
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software
breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
Real-time trace function
- 32K-cycle bus information recordable
(Bus, external trigger, time stamp)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
Real-time RAM monitor function
- 1,024 bytes
- Data/last access result
Hardware break function 6 points (Bus detection, interrupt, external trace signal)
Execution time measurement function
Time between program start and stop
Maximum/minimum/average execution time and pass count of specified four
zones.
Count clock: Equal to MCU Clock or 16MHz
C0 coverage 256KB
Event output Break x1, Event x6
External trigger input TTL level x8
Host machine interface
(see “2.3 Connecting the Host Machine”
on page 22)
Dedicated parallel (PC4701HS)
LPT parallel (PC4701M/PC4701U)
Serial (PC4701HS/PC4701M)
USB (USB 1.1, full-speed)*1 (PC4701U)
LAN (PC4701HS/PC4701U)
Power supply to emulator AC: 100 to 120V, AC: 200 to 240V (50/60Hz)
Power supply to emulation pod Supplied from the PC4701
Overseas standards
US EMI Standards [FCC part15 Class A]
CE marking [1998 Class A, EN55024: 1998]
*1 Available to connect the host machine that supports USB 2.0. With the USB interface, not all hardware (such as host
machine, USB devices, USB hub) combination will work and guaranteed.