Renesas Emulation Pod M3062PT3-RPD-E - Manual (Page 56)

M3062PT3-RPD-E User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0040-0600 Rev.6.00 July 01, 2006 Page 56 of 104
(3) Work area tab
1) Specifying the firmware
Specifying the firmware file
For the radio button of the firmware group box, be sure to click “Default”.
Specifying the work area
Specifies the top address which is used as a work area at the start address
area of the work area group box.
- For details on specifying the work area, refer to “3.2 Setting the Work
Area” (page 51).
- The top address of the work area is set to “2C00h” by default.
- In single-chip mode , set the work area address at “10000h”.
(4) Memory space expansion tab
Specifying the memory space expansion mode
When the memory expansion mode or micro processor mode is selected,
specify whether you want to use the memory space expansion mode or not.
When you use the memory expansion mode, select “Mode2”, and when not,
select “Normal”.
Note that “Mode1” cannot be selected.
(5) Clock tab
Specifying the target clock
Specify the clock sources supplied to the MCU (main clock and sub clock).
Select the appropriate clock sources according to the clock used by your
target MCU.
z
Internal
Emulation pod’s internal clock
z External
User system clock