Ryobi RY60512 - Manual (Page 18)

18
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Engine fails to start. Engine switch is in the off position.
No fuel in tank.
Spark plug shorted or fouled.
Spark plug is broken (cracked
porcelain or electrodes broken).
Ignition lead wire shorted, broken, or
disconnected from spark plug.
Ignition inoperative. Move switch to start.
Fill tank.
Replace spark plug.
Replace spark plug.
Replace lead wire or attach to spark
plug.
Contact authorized service center.
Engine hard to start. Water in gasoline or stale fuel mixture.
Too much oil in fuel mixture.
Engine is under or over choked.
Weak spark at spark plug.
Drain entire system and refill with fresh
fuel.
Drain and refill with correct mixture.
Adjust choke as necessary.
Contact authorized service center.
Engine lacks power. Air filter clogged. Clean or replace air filter.
Engine overheats. Insufficient oil in fuel mixture. Mix fuel as described in starting
instructions.
MAKE THE MOST OF YOUR PURCHASE!
Go to www.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi Help Line!
CALL
1-800-860-4050
www.ry
obitool
s.com
To register your Ryobi product or set up your eBox ™ account by regular mail, please print the following informa-
tion on a 3 in. x 5 in. card or standard postcard: your name, mailing address, phone numbers, email address,
Ryobi product(s) purchased with item number from package, and serial number for each product. Mail the card
to: Techtronic Industries North America, Inc., Attn. Ryobi Registration, 1428 Pearman Dairy Road, Anderson,
SC 29625. To receive information on our company and products, please include the following statement on
your registration card: “Send me information on your products and company using the contact information I am
providing with this product registration.”