Ricoh 70E User Manual
Page 80
Advertising
Preparation for Installation 4-32
II
L
00
4.3.2 Connection of the Container Stacker 1 and Container Stacker 2
1) Perform item 4.3.1.
2) Remove the two M3x8 Screws and Electrostatic Eraser from the Container stacker 2.
3) Install the Guide plate (U) with the Electrostatic Eraser (“FRONT” letter is surface.) by using
the two M3 Screws. (Be careful that the hair of the Electrostatic Eraser does not fall.)
4) Install the Joint Bracket (U) and Joint Bracket (L) by using the two M4x8 Screws.
5) Remove the six M4 screws and remove the rear cover from the Container Stacker 1.
Container Stacker 1
Rear Cover
M4 screws
Advertising