Roberts Radio RD-25 - Manual (Page 11)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
10
Signal strength display - DAB
1. Press and release the Tuning control until the lower line of the display
shows the signal strength.
2. Position your radio and carefully angle the telescopic aerial for best
reception using the signal strength display as a guide. Move your radio
around and position to give maximum number of black rectangles on
signal strength display. The clear unfi lled rectangle indicates minimum
signal level required for satisfactory reception.
1
Presetting stations - DAB
There are 5 memory presets on each radio band DAB, FM and MW.
1. Press the On/Off button to switch on the radio.
2. Tune to the required station as previously described.
3. Press and hold down the required Preset button until the display shows
e.g. "Preset 1 saved". The station will be saved under the chosen
preset button. Repeat this procedure for the remaining presets.
4. Stations stored in preset memories may be overwritten by following
the above procedure.
1
3