Ricoh FAX1700L User Manual
Page 97
If these settings have been made before, the messages on the display will not
always match those shown here. The setting already entered will appear along
with the word [
CHANGE?
]. In this case, press Yes to change the setting.
1
Press Function and 6, enter the
access code 2222, then enter 61.
You’ll get this:
INITIAL MODE Y/NEXTk
61 INITIAL SET
2
Press Yes.
Y/NEXTk
SET OWN NUMBER
3
Press Yes again.
OWN NO. KPAD
©©©©©©©©©©©©©©©©©©©©
4
Enter your phone number.
OWN NO. KPAD/Y/N
0111212-5551234©©©©©
❐
The format of the number is normally as follows:
International Dial Prefix, Your Country Code, Your Area Code, then you
must add a Pause, followed by your telephone number.
Check the International Dialing Prefix and the Country Code with your lo-
cal telecommunications operator. The example shown is for the USA; the
codes to add are 011 and 1.
5
Press Yes.
PROGRAMMED
will
flash on the display and you’ll get
Y/NEXTk
SET RTI
6
Press Yes.
RTI ABC
©©©©©©©©©©©©©©©©©©©©
7
Enter your office, company, or per-
sonal name, or any other appro-
priate identification. (Use the
quick Dial keys. See page 71 for
details.)
RTI ABC Y/N
XYZ COMPANY.
8
Press Yes.
PROGRAMMED
will
flash on the display and you’ll get:
Y/NEXTk
SET TTI
INSTALLATION
Initial Settings & Adjustments
88