Ryobi 2075RC - Manual (Page 7)

ASSEMBLY INSTRUCTIONS
7
INSTALLING AND ADJUSTING THE
LOOP HANDLE
If the loop handle is not assembled on this
model, use the following instructions:
1. Place the loop handle and bottom handle
clamp on the boom shaft (Fig. 1).
2. Install, one at a time, the four (4) screws and
four (4) hex nuts with a Phillips screwdriver.
NOTE: Install all four (4) screws before you
tighten any of them.
3. Adjust the loop handle to the desired
position.
4. Tighten the clamp screws securely.
Fig. 1
INSTALLING THE STRING GUARD
If the string guard is not assembled on this
model, use the following instructions:
WARNING: To avoid serious personal
injury, the string guard must in place
while operating this unit.
Fig. 2
1. Slide the string guard onto the guard mount
above the string head assembly. Align the
screw holes in the string guard with the
screw holes in the string assembly (Fig. 2).
2. Place the three hex nuts into the recessed
holes on top of the guard (Fig. 3).
Fig. 3
3. Install the screws into the holes from the
bottom of the guard (Fig. 4).
Fig. 4
4 Screws
Loop
Handle
Bottom
Handle
Clamp
4 Nuts
Hex Nuts
Top of
Hex
Nut
String
Guard
Screws
Guard
Mount