Ryobi RY70101A - Manual (Page 7)

7
ASSEMBLY
SILENCER GUARD ASSEMBLY
See Figure 4.
1. Remove silencer guard and two screws from the
owner’s kit.
2. Attach the silencer guard to the rear housing.
NOTE: Make sure the bent end of the silencer guard
fits securely into the opening of the rear housing.
3. Install two screws.
4. Tighten screws securely.
ASSEMBLY INSTRUCTIONS:
GRASS DEFLECTOR
See Figure 2.
1. Remove wing nut, flat washer, lock washer and bolt
from the Owner’s Kit.
2. Place grass deflector over shaft and bracket.
3. Install bolt through the slots in the tabs on grass
deflector and bracket on drive shaft housing.
4. Install flat washer, lock washer and wing nut.
5. Tighten securely.
FRONT HANDLE
See Figure 3.
1. Remove the front handle, bolt and wing nut from the
Owner’s Kit.
2. Install the front handle onto the top side of the drive
shaft housing and move it to a comfortable position.
3. Place the bolt through the front handle as shown.
Then install the wing nut.
4. Tighten the wing nut securely.
NOTE: Do not attempt to remove or modify the spacer.
This spacer limits the upper position of the handle grip.
See Figure 3.
WING NUT
FRONT HANDLE
BOLT
Fig. 3
GRASS DEFLECTOR
BRACKET
BOLT
FLAT WASHER
LOCK WASHER
WING NUT
Fig. 2
Fig. 4
SCREWS
SILENCER
GUARD
REAR
HOUSING
BENT END OF
SILENCER GUARD
OPENING IN REAR
HOUSING
TORQUE
WRENCH