Ryobi PLT3043E - Manual (Page 15)

15
PROBLEM PROBLEM PROBLEM PROBLEM PROBLEM POS POS POS POS POSSIBLE CA SIBLE CA SIBLE CA SIBLE CA SIBLE CAUSE USE USE USE USE SOLUTION SOLUTION SOLUTION SOLUTION SOLUTION
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
TROUBLESHOOTING
1. Check spark. Remove spark plug. Reattach the
spark plug cap and lay spark plug on metal
cylinder. Pull the starter rope and watch for
spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
2. Push primer bulb until bulb is full of fuel. If bulb
does not fill, primary fuel delivery system is
blocked. Contact a service dealer. If primer
bulb fills, engine may be flooded (see next
item).
3. Remove spark plug, turn trimmer so spark plug
hole is aimed at the ground. Make sure lever is
in the “WARM START” position and pull starter
cord 10 to 14 times. This will clear excess
fuel from engine. Clean and reinstall spark plug.
With the throttle trigger fully depressed, pull
starter cord three times with lever at “WARM
START” position. If engine does not start,
move choke lever to “COLD START” and follow
normal starting instructions in "STARTING
AND STOPPING" section. If engine still fails
to start, repeat procedure with a new spark
plug.
4. Contact a service dealer.
Release throttle trigger. Refer to “Starting and
Stopping” earlier in this manual.
*Turn “L” needle counterclockwise 1/16 turn. If
“L” low needle can not be turned counterclock-
wise, do not force plastic limiter caps. Contact a
service dealer. See Figure 18.
1. Use fresh fuel and the correct 2-cycle oil mix.
2. Clean air filter. Refer to “Replacing and
Cleaning Air Filter” earlier in this manual.
3. Turn “H” needle clockwise 1/16 - 1/8 turn. See
Figure 18.
Turn idle speed screw clockwise to increase
idle speed. See Figure 18.
1. Lubricate with silicone spray.
2. Install more string. Refer to “String Replace-
ment” earlier in this manual.
3. Pull strings while alternately pressing down on
and releasing spool retainer.
4. Remove string from spool and rewind. Refer to
“String Replacement” earlier in this manual.
5. Advance string at full throttle.
Engine will not start:
Lever will not go into the
"COLD START" position:
Engine starts but will not
accelerate:
Engine does not reach full
speed and emits excessive
smoke:
Engine starts, runs, and
accelerates but will not
idle:
String will not advance:
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder now than
when new.
Throttle trigger is depressed.
Carburetor requires adjustment.
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires adjustment.
Carburetor requires adjustment.
1. String welded to itself.
2. Not enough string on spool.
3. String worn too short.
4. String tangled on spool.
5. Engine speed too slow.