Ryobi RY41002A - Manual (Page 4)

Page 4
ELECTRICAL SAFETY RULES
n Make sure the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
n Do not abuse the power cord. Never carry the product
by the cord. Never yank the plug out of the receptacle.
Keep the cord away from heat, oil, and sharp edges.
n To reduce the risk of electrical shock, use only round-
jacketed extension cords approved for outdoor use,
such as cords of type SW-A, SOW-A, STW-A, STOW-
A, SJOW-A, SJTW-W, or SJTOW-A. Since this tool is
double insulated, you may use a 2-wire extension cord
(an extension cord without a ground). However, you
may also use a 3-wire extension cord (an extension
cord with a ground) that has a NEMA-type connector
(parallel blade, U ground). Extension cords are available
from your local retailer.
n Be sure to use a cord that is heavy enough to carry the
current that your product will draw. The correct cord
size depends on cord length and amperage rating (see
figures below). An undersized cord set will cause a drop
in line voltage resulting in loss of power and overheating.
Use of an improper extension cord could result in a risk
of fire and electric shock. If an extension cord must be
used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those on the plug on the
charger.
b. That the extension cord is properly wired and in good
electrical condition; and
c. That the wire size is large enough for the AC ampere
rating of the product as specified below:
Cord Length (Feet) 25' 50' 100'
Cord Size (AWG) 16 14 12
Note: AWG = American Wire Gage
n
To reduce the risk of electrical shock, this product has
a polarized plug (one blade is wider than the other)
and requires the use of a polarized extension cord.
This product’s plug fits into a polarized extension cord
in only one way. If the plug does not fit fully into the
extension cord, reverse the plug. If the plug still does
not fit, obtain a correct polarized extension cord. Use
of a polarized extension cord requires use of a polar-
ized wall outlet. This product’s plug fits into a polarized
wall outlet in only one way. If the plug does not fit fully
into the wall outlet, reverse the plug. If the plug still
does not fit, contact a qualified electrician to install the
proper wall outlet. Do not change the product plug, the
extension cord receptacle, or the extension cord plug
in any way.
n Ground Fault Circuit Interrupter (GFCI) protection should
be provided on the circuits(s) or outlet(s) used for this
product. Receptacles with built-in GFCI protection are
available and may be used.
n Inspect extension cords for deterioration, cuts, or
cracks in the insulation. Repair or replace the cords if
any defects appear.
n A nameplate on the product indicates the unit’s volt-
age. Never connect the product to an AC voltage that
differs from this voltage.
MAINTENANCE RULES
n Maintain the product with care. Follow instructions for
changing accessories. Keep the product dry, clean,
and free from oil and grease.
n Release the trigger, allow the motor to stop, and unplug
the product before making adjustments or repairs.
n Do not use the product if parts have been damaged.
Check the product to make sure that it will operate
properly and perform the intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, and any other condition that may
affect the unit’s operation. Inspect the unit’s power con-
nection. Any part that is damaged should be properly
repaired or replaced by a Homelite authorized service
center.
n Keep the product clean of grass clippings and other ma-
terials that may become lodged in the cutting lines.
n Never douse or squirt the product with water or any
other liquid. Keep handles dry, clean and free from
debris. After each use, clean with a soft, dry cloth.
SERVICE RULES
n Service on this product must be performed by qualified
repair personnel only. Service or maintenance performed
by unqualified personnel could result in injury to the
user or damage to the product. Such service may also
void your warranty.
n Use only identical replacement parts when servicing
the product. Follow the instructions in the Maintenance
section of this manual. Use of unauthorized parts or
failure to follow maintenance instructions may create
a risk of shock, serious injury to the user, or damage to
the product. Such use may also void your warranty.
STORAGE AND TRANSPORTATION RULES
n Stop the motor when you are waiting to cut or when
you are walking from one cutting location to another.
n Store the product inside in a dry place. Store the
product up high or lock it up to prevent unauthorized
use or damage. Keep the product out of the reach of
children.
n Secure the product when transporting it.
n Save these instructions. Refer to them frequently and
use them to instruct others who may use this
product. If you loan someone this product, loan
these instructions also.
SPECIFIC SAFETY RULES