Roland BR-864 - Manual (Page 147)

147
Section 5
Initializing the BR-864’s settings
Initializing all the BR-864’s
settings
The following settings are initialized together at one time.
• System Settings
• Effects (User Patches/Song Patches)
• Rhythm Guide (Arrangements/Patterns/Drum Kits)
1. Press [UTILITY].
2. Press CURSOR [ ] [ ] to move the cursor to “INI,”
and press [ENTER].
fig.05-601d
3. Press PARAMETER CURSOR [ ] [ ] to move the
cursor to “ALL,” and press [ENTER].
The confirmation message “Are you sure?” appears in
the display.
fig.05-602d
4. To continue the initialization, press [ENTER] (YES).
To cancel, press [EXIT] (NO) (or [UTILITY]).
When [ENTER] is pressed, initialization begins.
After the initialization has been completed, you are
returned to the Play screen.
You can perform the same initialization with “INIT
ALL,” by holding down INPUT SELECT [GUITAR/
BASS], [MIC], and [LINE] while turning the POWER
switch ON, then pressing [ENTER].
Initializing the system settings
Follow the procedure below to initialize the system
parameters.
A list of the initial settings for each parameter is given in
the “Parameter List” (p. 178).
1. Press [UTILITY].
2. Press CURSOR [ ] [ ] to move the cursor to “INI,”
and press [ENTER].
fig.05-603d
3. Press CURSOR [ ] [ ] to move the cursor to “SYS,”
and press [ENTER].
The confirmation message “Are you sure?” appears in
the display.
fig.05-604d
4. To continue the initialization, press [ENTER] (YES).
To cancel, press [EXIT] (NO) (or [UTILITY]).
When [ENTER] is pressed, initialization begins.
After the initialization has been completed, you are
returned to the Play screen.