Roberts Radio CRD-51 - Manual (Page 12)

11
Operating your radio – FM autotune
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the On/Off button to switch on your radio.
3. Press the FM/DAB button to select the FM band.
4. Press and hold down the Tuning Up or Down buttons until the
frequency in the display begins to change. Your radio will scan the
FM waveband, stopping each time it finds a station of sufficient
strength.
5. After a few seconds, the display will update and show station name
if RDS informationis available.
6. To find other stations, Press the Tuning Up or Down buttons as
before.
7. When the end of the waveband is reached, your radio will recommence
tuning from the opposite end of the waveband.
8. Press the Volume Up or Down buttons to the set the required volume
level.
9. To switch off your clock radio press On/Off button.
1,9
3
4,6
4,6
8
8