Roberts Radio CRD-51 - Manual (Page 5)

If.you.need.any.further.advice,.please.call.our.Technical.Helpline.on.:-
020 8758 0338 (Mon-Fri)
4
Using your clock radio for the first time
1. Place your clock radio on a flat surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
3. Plug the mains lead into a wall socket and switch on the wall socket.
the display will show “ROBERTS” and after few seconds a station
scan search will be performed automatically. The display will show
progress of the station search e.g. “>>>> 18”. The number on the
right of the display is the number of stations that have been found.
The display will then show “SET CLOCK”, after a short time the current
time will appear on the display.
4. If no stations are found, “NO CLOCK” will be displayed. It may necessary
to relocate your clock radio to a position giving better reception. You
should then carry out an autoscan to find stations as described on
page 8.
IMPORTANT: The mains plug is used as the means of connecting the
radio to the mains supply. The mains socket used for the radio must remain
accessible during normal use. In order to disconnect the radio from the
mains completely, the mains plug should be removed from the mains
socket outlet completely.
Characters appearing on the LCD display indicate that the radio is connected
to and powered from the mains supply.