Operation – Ryobi CS30 RY30524 User Manual

Page 18

Advertising
background image

18

OPERATION

STARTING AND STOPPING

See Figures 21 - 22.
Trimmer should be on a flat, bare surface for starting. The
starting method differs depending on whether the engine
is cold or warm.
To start a cold engine:

Slowly press the primer bulb seven (7) times.

Rotate the choke dial clockwise to the

FULL CHOKE

position.

Squeeze throttle trigger fully and continue to hold through

remaining steps.

Pull the starter grip sharply until engine attempts to run

(no more than 4 pulls).

Rotate the choke dial counterclockwise to the

HALF

CHOKE position.

Pull the starter grip sharply until the engine runs.

Allow the engine to run for 10 seconds.

Rotate the choke dial counterclockwise to the

RUN

position.

To start a warm engine:

Slowly press the primer bulb seven (7) times.

Pull the starter grip sharply until the engine runs.

TO STOP THE ENGINE:

See Figure 21.
Release the throttle trigger and press and hold STOP on
the engine switch.

IF ASSISTANCE IS REQUIRED STARTING
THIS PRODUCT:

Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-860-4050

Fig. 21

THROTTLE

TRIGGER

PRIMER

BULB

PRIMER BULB

Fig. 22

FULL

CHOKE

HALF

CHOKE

RUN

CHOKE

DIAL

STARTER

GRIP

STARTER

SWITCH

Advertising
This manual is related to the following products: