Roland HP-203 - Manual (Page 22)

20
Before You Play
You can use headphones to enjoy the HP203 without
disturbing those around you, such as at night. Since the
HP203 has two headphone jacks, two people can also use
headphones simultaneously.
If you’re using only one set of headphones, you may connect
them to either of the two headphone jacks.
fig.Headphones-e.eps
1. Plug the headphones into the PHONES jack
located at the left of the HP203’s bottom
panel.
If headphones are connected, no sound will be output
from the HP203’s speakers.
2. Use the HP203’s [VOLUME] knob (p. 18) to
adjust the headphone volume.
Cautions when Using Headphones
• To prevent damage to the cord’s internal conductors,
avoid rough handling. When using headphones, mainly
try to handle either the plug or the headset.
• Your headphones may be damaged if the volume of a
device is already turned up when you plug them in.
Minimize the volume before you plug in the headphones.
• Excessive input will not only damage your hearing, but
may also strain the headphones. Please enjoy music at an
appropriate volume.
• Use headphones that have a stereo 1/4” phone plug.
Whenever you are not using the headphones, you can hang
them on the headphone hook of the HP203.
Attaching the Headphone Hook
1. Press and twist the headphone hook included
with the HP203 into the hole in the bottom left
of the HP203 (refer to the figure below).
2. Turn the headphone hook wing nut to secure
the headphone hook.
fig.HeadphonHook.eps
Do not hang anything other than headphones on the
headphone hook. Doing so may damage the
instrument or the hook.
Listening through Headphones
Headphones
Using the Headphone Hook
Headphone Hook
NOTE
HP203_e.book 20 ページ ２００６年１２月８日 金曜日 午前９時３３分