Changing the volume, Sounding a count to keep your timing accurate, Song (p. 39) – Roland HP-203 User Manual
Page 41
39
Performing
The volume of the metronome can be adjusted, with 11 volume levels available.
This is set to “5” when the instrument is turned on.
fig.Panel-MetronomeVol-e.eps
1.
While holding down the [Metronome] button, press the [-] or [+] button.
The display will indicate the metronome volume.
fig.d-5.eps
When the metronome volume is set to “0,” the metronome sound does not play.
A “count-in” is a count that is sounded before the song begins to play.
If you’re playing along with a song, you can sound a count to make it easier to
synchronize your own playing with the song.
fig.Panel-CountIn-e.eps
1.
While holding down the [Metronome] button, press the [
] button.
A two-measure count sounds before the song plays.
A “count-down” is a count that is sounded at the end of the song’s introduction (before
you begin playing the keyboard) (p. 71).
Changing the Volume
Sounding a Count to Keep your Timing Accurate
HP203_e.book 39 ページ ２００６年１２月８日 金曜日 午前９時３３分