Ryobi RY42110 - Manual (Page 14)

12 - English
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Motor won’t start Lower tube hasn’t been telescoped
out to its full length
No power (power failure)
Connection lead wire defect
Motor or switch defect
Pull the lower tube out to its full
length.
Check circuit breaker.
Check fuse
Check circuit breaker.
Replace lead or have lead checked
(electrician); never use defective lead.
Contact the authorized service center.
Material is not sucked in properly (re-
duced vacuuming power) Machine is clogged or blocked
Vacuum bag too full
Speed setting too low
Clean tool
Empty bag
Adjust to higher speed
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.