Radio Shack 32-2058 - Manual (Page 10)

10
The Basics
presetting audio inputs
Before mixing your audio sources (devices connected to LINE
1, PHONO 1, PHONO 2, LINE 2, LINE 3, LINE 4, LINE 5, LINE 6), you must set
their input signal level to each channel input (CH1, CH2, CH3,
etc.). You do not have to mix every connected input source.
1. Set the channel selector to the desired input source.
2. Play the selected input source.
3. Adjust HIGH, MID, and BASS as desired. See “using the
special controls” on Page 18. If you are using an external
equalizer, leave the controls set to 0 and adjust the tone
on the external equalizer.
4. Adjust the volume on your headphones (CUE LEVEL) or
receiver to a comfortable listening level.
All GAIN controls set midway
between MIN and MAX.
CH1, CH2, CH3, and CH4 to 0.
DJ MIC LEVEL and AUX LEVEL to 0.
SEND ASSIGN and CUE ASSIGN to OFF.
CUE LEVEL to 0.
SEND, RECEIVE, and MASTER
set to 0.
All HIGH, MID, and BASS controls to 0.