Radio Shack 32-2058 - Manual (Page 21)

21
Beyond the Basics
replacing the fuse
The mixer uses a fuse for protection against surges and short
circuits. If the mixer suddenly turns off and will not turn on,
check the fuse. If necessary, replace it with a 0.5-amp, 250-
volt, fast-acting, 1
1 /
4
x 1 /
4
inch fuse (not supplied).
1. Disconnect power from the mixer.
2. Use a Philips screwdriver to remove the fuse
compartment cap.
3. Remove the old fuse and insert a new one. Make sure you
replace the fuse only with another fuse of the same type
and rating.
4. Replace the fuse compartment cap.
5. Reconnect the mixer to power.
