Runco Vision 85 - Manual (Page 29)

Installation
Vidikron Vision 85 Owner’s Operating Manual 17
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the Vision 85 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 18
2 Connect the VHD Controller to the projector 23
3 Connect signal sources to the VHD Controller 24
4 Connect external controller to RS-232 port (optional) 28
5
Connect other home theater components to 12-volt trigger
outputs (optional) 28
6 Apply power to the projector 30
7
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 30
8
Primary lens adjustments: projected image size (zoom),
position (shift) and focus 20, 31
9 Install CineWide anamorphic lens (optional) 32
10
CineWide lens adjustments: position, pitch (angle), geometry
and focus 33
11
Projector calibration – Analog 1080i and lower-resolution
signals:
Adjust the following for Component SD input; save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
39 through 52
12
Repeat Step 11 for S-Video 1, S-Video 2, Composite Video,
HD1 and HD2 inputs
13
Projector Calibration – Digital 1080i or 1080p signals:
Adjust the following for HDMI 1 and HDMI 2 inputs:
• Brightness
• Contrast
• Color level
• Tint
• Input position 52 through 61
Note