5 connections to the vision 85 and vhd controller, Connector panel access, Connecting the projector to the vhd controller – Runco Vision 85 User Manual
Page 35: Connections to the vision 85 and vhd controller, 6. connecting the projector to the vhd controller, Pre l iminar y, Risk of electric shock do not open
Vidikron Vision 85 Owner’s Operating Manual
23
PRE
L
IMINAR
Y
3.5
Connections to the Vision
85 and VHD Controller
Proceed as follows to connect the VHD Controller to the Vision 85, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on connectors
that have them.
Connector Panel Access
To access the connector panel, press
the door release button so it pops out.
Turn the knob clockwise or
counter-clockwise and pull gently on it
to open the door.
Connecting the Projector to
the VHD Controller
The Vision 85 is designed to receive only video input signals directly from the companion
VHD Controller/Processor. Connect all signal sources to the appropriate inputs on the rear
panel of the VHD. The signal from the VHD is then output to the Vision 85 projector through
an HDMI cable.
Connect the HDMI and RS-232 outputs of the VHD Controller to the corresponding inputs of
the Vision 85; see Figure 3-6.
Figure 3-6. Connecting the Projector to the VHD Controller
You CANNOT connect signal sources directly to the Vision 85. They MUST
be routed through the VHD Controller for proper operation.
Note
HDMI
HDMI
AC IN 100-240V 50-60Hz
AC IN 100-240V 50-60Hz
TRIGGER
TRIGGER
IR
IR
RS-232 OUT
RS-232 OUT
RETURN
ENTER
DOWN
UP
LEFT
RIGHT
RETURN
ENTER
DOWN
UP
LEFT
RIGHT
ON
ON
MENU
MENU
ASPECT
RATIO
ASPECT
RATIO
STANDBY
STANDBY
Pb
Pr
Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1
2
R/Pr
G/Y
B/Pb
R/Pr
G/Y
B/Pb
H
V
HDMI 1
HDMI 2
HDMI Out
H
V
TRIGGERS
RS-232 Out
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS:
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Made In USA
RS-232 OUT
HDMI OUT