Radio Shack 40-1430 - Manual (Page 3)

3
12'4#6+10
1. Place the unopened speakers on a level surface.
2. Slide POWER to OFF and rotate VOLUME to MIN until it
stops.
3. Pull the speaker cable’s 3.5mm stereo plug on the right
side all the way out and stop pulling when the white
stripe on the cable appears. Insert it into the notebook
computer’s or the stereo’s audio output jack.
4. Push the speaker cabinet’s latch on the left side of the
cabinet up and hold it. Then open the speaker cabinet.
5. Slide POWER to ON . The indicator lights.
6. Adjust VOLUME and TONE as desired.
7. When you finish using the speakers, slide POWER to
OFF . The indicator goes off. Close the speaker cabinet
until it clicks.
8. Disconnect the cable then pull the cable again so it
automatically retracts back into the cabinet. Hold onto
the stereo plug while retracting the cable to keep it from
hitting your hand or other objects.
±
%#4'
Keep the speakers dry; if they get wet, wipe them dry
immediately. Use and store the speakers only in normal
temperature environments. Handle the speakers carefully;
do not drop them. Keep the speakers away from dust and
dirt, and wipe them with a damp cloth occasionally to keep
them looking new.

5'48+%' #0& 4'2#+4
If your speakers are not performing as they should, take
them to your local RadioShack store for assistance. To
locate your nearest RadioShack, use the store locator
feature on RadioShack's website (www.radioshack.com), or
call 1-800-The Shack (843-7422) and follow the menu
options. Modifying or tampering with the speaker's internal
components can cause a malfunction and might invalidate
their warranty.
±
016'
±
• Pulling the cable so it exceeds
the white stripe prevents the
cable from retracting smoothly.
If the cable stops or retracts
back while pulling, slightly pull
the cable to release it for
retraction. Then pull the cable to
the desired length to release it.
• If the cable stops during
retraction, pull it again and hold
it until it completely retracts
back into the cabinet.

%#76+10

You might permanently damage
your speakers by cleaning them
with a vacuum cleaner. Use a
feather duster or a soft loose cloth
instead.