RCA VR636HF - Manual (Page 65)

63
appendix: reference
Clock shows incorrect time or date
• Power interruption. Automatic clock set was not turned on or did not work properly. Check time zone and daylight-
savings settings.
• Make sure VCR or cable box is tuned to channel carrying XDS information.
• Auto clock set is not supported by digital satellite receivers. Set the clock manually.
Time did not adjust for daylight-saving time
• Check to make sure daylight-saving feature is set correctly.
VCR makes noise when stopped
• VCR is removing tape from heads. This is normal. The head cylinder inside the VCR will continue to rotate for a few
minutes after you put the VCR in the stop mode.
Will not AUTO CHANNEL SEARCH active channels correctly
• Check to make sure the antenna connections are secure and correct.
• Check to make sure the Signal Type: CABLE/ANTENNA feature is set correctly.
• If Detect Automatically was selected for the Signal Type in the AUTO CHANNEL SEARCH menu, try using either CABLE
TV or ANTENNA instead.
• May not be necessary if using a cable box for all channels. Contact your local cable company for more information.
Tape plays back in slow motion
• Press PLAY to return to normal playback.
Cannot select channels over 69
• Cable channels over 69 can only be selected if Signal Type: CABLE/ANTENNA feature is set to CABLE.
Cassette with safety tab removed does not start to play automatically
• Check to make sure the Auto Play ON/OFF feature is set to ON.
TIMER indicator flashes
• Check to make sure there is a cassette in the VCR when a timer recording is set.
Time counter disappears during searching
• This is normal.
On-screen menus appear in English, French, or Spanish
• Check LANGUAGE feature.