Raymarine autopilot control unit - Manual (Page 30)

Chapter 2: Basic Operation 13
Contrast
To set the display contrast:
1. With the autopilot in Standby mode, hold down the disp key for
1 second to show the illumination adjust display.
2. Hold down the disp key for 1 second again, to display the
CONTRAST adjust page.
3. Use the up and down arrow keys to set the required contrast level
(from
1 to 15).
The display times out to normal operation after 10 seconds of keypad
inactivity.
2.7 Data Pages
The disp key is used to cycle through Data Pages of SeaTalk or
NMEA data. Once a Data Page is selected, this page becomes the
principal autopilot display. The autopilot mode displays (Standby,
Auto, Track Wind and Manual) then become “pop-ups”, and are
displayed whenever the autopilot mode is changed or a course change
is made. The duration of pop-up pages is user-adjustable, from 1 to 10
seconds. You can use Data Pages as follows:
• Press disp to display each Data Page in turn.
• When the last Data Page is cycled, the display returns to the current
autopilot mode display (for example, Standby).
• To return to a previous Data Page, press disp for 1 second within 2
seconds of displaying a page. You can continue to move backwards
through the Data Page sequence in this way.
Up to 15 Data Pages are available using the disp key. The number of
pages, and the information displayed on each page, depends on the
selections made in User Setup (see Section 4.1).
The following diagram shows the default Data Page settings.
118ch02.p65 07/01/99, 12:41 13