Latitude, Wind trim, Autorelease – Raymarine autopilot control unit User Manual
Page 66: Response
Chapter 4: Customising the System
49
Latitude
This screen is only used if AutoAdapt is set to North or South.
Use the up and down arrow keys to set the value to your vessel’s
current latitude, to the nearest degree.
Range:
0° to 80°
Default:
0°
Note: If valid latitude data is available via SeaTalk or NMEA, it will be
used instead of this calibration value.
Wind Trim
This varies the response of the autopilot when in Wind mode.
Range:
1 = Normal setting
2 = Faster response for wind shifts
Default:
1
AutoRelease
AutoRelease provides emergency manual override, should it be
necessary, to avoid an obstacle at the last moment. This option only
applies to cable-operated sterndrive actuators – for all other systems
this option should be set to off.
Range:
OFF
On
Default:
for Pilot Type Displacement OFF
for Pilot Type Semi-Displacement
OFF
for Pilot Type Planing
OFF
for Pilot Type Sterndrive
On
Response
This is the power-on response setting. The response level can be
changed during normal operation (see Section 3.3).
Range:
1 = Auto Seastate
2 = Auto sea state inhibit
3 = Auto sea state inhibit with counter rudder
Default:
1
118ch04.p65
07/01/99, 12:42
49