Runco CINEMAWALL XP-OPAL65 - Manual (Page 69)

CinemaWall Installation/Operation Manual 55
PRE
L
IMINAR
Y
6.1
RS-232 Connection
and Port Configuration To interface the CinemaWall with a home theater automation/control system or a PC
running terminal emulation software, connect it to your control system or PC as shown in
Figure 3-5. Use a straight-through cable.
Configure the RS-232 controller or PC serial port as follows:
• 9600 baud
• No parity
• Eight (8) data bits
• One (1) stop bit
• No flow control
6.2
Serial Command
Syntax Serial commands to the CinemaWall take the following form:
• You can send commands in either hexadecimal or ASCII format.
• ASCII commands are case-sensitive and must be in UPPERCASE.
• Commands begin with the “Start of Text” (STX) character (02h or <Ctrl> B in ASCII),
followed by the command data, the colon character (3Ah or : in ASCII), command
parameter (1 to 8 bytes; refer to Table 6-1) and the “End of Text” (ETX) character (03h
or
<Ctrl> C in ASCII). Not all commands require parameters to be sent with them;
examples of such commands are PON (power on), POF (power off) and IMS (toggle
input selection).
• You do not need to send a carriage return after the command.
• When sending multiple commands, be sure to wait for a response to the first command
to come from the CinemaWall before sending the next command.
• When you send a valid command, the CinemaWall executes it and echoes the
command (without the parameter) back to the controller.
• If you send an invalid command, the CinemaWall sends ER401 back to the controller.
Examples To select the PC input, send the following sequence:
To set the Picture Level (contrast) to its highest possible level (+30), send the following
sequence:
6. Serial Communications
STX Command (3 bytes) Parameter (3 bytes) ETX
Hex 02 49 4D 53 3A 50 43 31 03
ASCII <Ctrl> B I M S : P C 1 <Ctrl> C
STX Command (3 bytes) Parameter (6 bytes) ETX
Hex 02 56 50 43 3A 50 49 43 30 33 30 03
ASCII
<Ctrl> B V P C : P I C 0 3 0 <Ctrl> C