Regent Sheffield MS249R - Manual (Page 7)

7
Mode of
operation:
Set slide switch
on sensor to:
How to set
power switch:
Continuous Override
Mode (standard
floodlight setting)
Lights should stay on
continuously both day
and night (must be reset
manually).
TEST
Turn the power off
for 5 seconds then
back on.
Is there power to the fixture?
• Check to see that the circuit breaker has not been tripped.
• Be sure the wall switch is in the ON position.
• Be sure that the bulbs are not burned out or broken.
Is the surrounding external ambient light too bright? (If so, the unit
may think it’s daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
TURN OFF POWER BEFORE CONTINUING.
Is the wiring to the fixture loose?
• Check wiring, and reconnect if necessary using wire nuts
provided.
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects such
as trees, traffic, etc.
TEST FOR YOURSELF.
• Cover the sensor lens with cardboard to prevent
sensor from detecting motion. If the lights stay off,
something in the detection zone is triggering the sensor.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
*If the lights stay on with sensor lens covered,
contact customer service.
Is the unit in the AUTO mode?
• Make sure the unit is not in one of the two NIGHT TIME ON
modes.
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects such
as trees, traffic, etc.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
If there is no motion, then the unit may be in the override mode.
• Turn the light switch to the OFF position for 90 seconds, and
then back to the ON position. This will send the unit bac k
into the AUTO mode.
*If the lights continue to stay on, contact customer
service.
Is the unit in the AUTO mode?
• Make sure the unit is not in one of the two NIGHT TIME ON
modes.
OUTDOOR LIGHTS DO NOT
COME ON WITH MOTION AT
NIGHT
OUTDOOR LIGHTS COME ON
FOR NO APPARENT REASON
AT NIGHT
LIGHTS STAY ON AT NIGHT
AND DO NOT TURN OFF
(continued)
L What to do if . . .
Return to AUTO
or NIGHT TIME ON
Settings
(motion activated)
From any of the above
settings
AUTO
or
ALL NIGHT TIME
ON MODES
Turn the power off
for at least 90 seconds
then back on.
MS249R_MS249RW 325-1486.qxd 6/20/06 4:02 PM Page 7