Regent Sheffield MS249R - Manual (Page 8)

8
Cooper Lighting (“the Company”) warrants this product (“the product”)
against defects in material or workmanship for a period of two years from
date of original purchase, and agrees to repair or, at the Company’s option,
replace a defective product without charge for either replacement parts or
labor during such time. This does not include labor to remove or install
fixtures.
The light given off from the unit’s own lamp(s) is affecting the
motion sensor.
• Re-aim lamps.
• Reposition motion sensor.
Is the switch on the bottom of the motion sensor in the test mode?
• Move the switch to the AUTO or NIGHT TIME ONposition.
Is the motion detector shado wed?
• Reposition motion sensor.
Is the surrounding external ambient light too bright? (If so, the
unit may think it’s daytime.)
• Re-aim the head.
• Relocate or reposition the unit a way from the light.
Are you allowing adequate time to enter the dusk to dawn mode?
• Turn the light switch to the OFF position for 5 seconds and
then back to the ON position.
Is there more than one fixture on an indoor wall switch?
• If so, put them on separate switches.
Is the sensor in the correct SETTING?
• Move slide switch to 2 hr or 4 hr setting.
Was NIGHT TIME ON setting changed after lights were already on
in a different NIGHT TIME ON setting?
• NIGHT TIME ONmode setting cannot be changed until
the next dawn once light is operating in that setting. See
“How to select your desired feature”.
If lights do not come on at all in NIGHT TIME ONmode:
Is the surrounding external ambient light too bright? (If so,
the unit may think it’s daytime.)
• Re-aim the head.
• Relocate or reposition the unit a way from the light.
Is the indoor module turned up loud enough?
• Adjust volume slide switch on side of the module.
Is the indoor module set to the same house code as the outdoor
sensor?
Have you tried all other house codes?
•Tr y all house codes making sure sensor house code
matches indoor module house code .
• Move the module to a different outlet.
Is the switch on the lamp turned on?
Is it night outside?
• The indoor lamp will automatically turn on whenever the
outside lights turn on (only at night).
Is the indoor module set to the same house code as the outdoor
sensor?
Is the indoor lamp controlled by a wall switch?
• If so, make sure wall switch is turned on.
Has the lamp been turned on by setting the MODEOFOPERA-
TIONto LAMPON?
• If so, the lamp will stay on until the slide switch is moved to
another mode.
Is it night outside?
• The indoor lamp will automatically turn on whenever the
outside lights turn on (only at night).
Is the indoor module set to the same house code as the outdoor
sensor?
LIGHTS CONTINUOUSLY
BLINK ON AND OFF AT NIGHT
LIGHTS ARE ON
DURING THE DAY
CANNOT ACTIVATE DUSK TO
DAWN MODE AT NIGHT
(OVERRIDE)
LIGHTS DO NOT COME ON
IN NIGHT TIME ON MODE
LIGHTS WILL NOT RESPOND
TO SELECTED NIGHT TIME ON
SETTING
INDOOR ALARM DOES NOT
SOUND
INDOOR LAMP DOES NOT
TURN ON
INDOOR LAMP DOES NOT
TURN OFF
(continued)
Two year limited warranty
MS249R_MS249RW 325-1486.qxd 6/20/06 4:02 PM Page 8