Raymarine autopilot - Manual (Page 60)

Chapter 5: Installing the ST6001+ 47
5
In
stal
ling t
he
ST6
001+
5.2 Control unit installation
Surface mount control units
To fit a surface mount control unit:
1. Apply the surface mount template (supplied at the back of this
handbook) to the selected bulkhead.
2. Mark the centers of the two fixing holes and the cable boss.
3. Drill two 5 mm (
3 /
16
in) diameter holes for the fixing studs.
4. Use a 90 mm (3.55 in) diameter cutter to drill the hole for the
cable boss.
5. Peel the protective sheets from the self-adhesive gasket, then stick
the gasket into position on the rear of the control unit.
6. Screw the two fixing studs into the threaded sockets on the rear of
the control unit.
7. Pass the SeaTalk/NMEA cables through the bulkhead and
connect them to the appropriate terminals (as described later in
this chapter).
8. Assemble the control unit to the bulkhead.
9. Secure the control unit with the thumb nuts provided.
Hand-tighten the thumb nuts – do NOT use a wrench.
D3243-3
Cable boss
Self-adhesive
gasket
Fixing stud Thumb nut