Operation – Remington 490 User Manual
Page 16
16
101274
CARE OF YOUR POWERDRIVER™
Clean your Powerdriver™ after each day’s use. Clean chamber
with accessory wire brush, part number 56485. Apply good
quality penetrating lubricant spray (such as WD-40) sparingly
and wipe dry.
NOTE: The labor regulations of many states require that the
operator of this tool on a job site be thoroughly trained and
certified for compentence prior to operating this tool. For
certification procedures, call: Technical Services Department,
1-800-858-8501 or visit www.desatech.com.
PISTON OVERDRIVE
If the tool does not open after firing and the piston is 1/2 inch or
more out of the muzzle:
1. Strike muzzle end of Powerdriver™ against hard surface to
force piston back into muzzle.
2. Eject the power load (See step 7 of
Operation).
OVERDRIVE
Operation