Remington 490 - Manual (Page 23)

23 101274
IMPORTANT
• Recommended for use with Remington
® power loads and
power fasteners.
• Do not use power fasteners longer than 2 1 /
2
" or power
washer fasteners longer than 3".
• If power fastener goes below the top surface of the board,
use penetrating control disc (see illustration below) or
washered SPW-type power fasteners.
• Always wear approved eye and ear protection.
* Use power fastener with penetration control disc, part
number 015549.
Power load listings are recommendations only. If you are in
doubt, try a test fastening using the next lightest power load.
Power fasteners and power loads are available in blister packs
of 25 and cartons of 100.
Application Chart
Load Color Code
Stock Level Load Case
Number Number Strength Body Head
A22C1 1 light brass Gray
A22C2 2 medium brass Brown
A22C3 3 heavy brass Green
A22C4 4 extra heavy brass Yellow
.22 CALIBER Type A, neck-down crimp loads for powder
actuated tools
IMPORTANT
This tool is designed to use .22 caliber neck-down crimped
loads, power levels 1 (gray) through 4 (yellow).
5/8"
Straight Wadded
Power Load
Neck-Down Crimped
Power Load
CAUTION: Do not use any load other than
the .22 caliber neck-down crimped load.
Other types of loads will cause load-ejection
problems.