Maintenance, Spark plug, Angle gear – Ryobi 225L User Manual

Page 19: Two-part shaft, Maintenance schedule

Advertising
background image

English –

19

MAINTENANCE

Spark plug

The condition of the spark
plug is affected by:

• An incorrect carburettor

setting.

• An incorrect fuel

mixture (too much or
faulty oil).

• A dirty air filter.

These factors cause
deposits on the spark plug
electrode that may result in
malfunction or starting
difficulties.

If the machine is low on power, difficult to start or runs
poorly while idling always check the spark plug first.

If the spark plug is dirty, clean it and at the same time check
that the electrode gap is 0.5 mm. The spark plug should be
changed after about one month of operation or earlier if
necessary.
NOTE! Always use the recommended type of spark plug. An
incorrect spark plug can damage the cylinder/piston.

0,5 mm

Angle gear

The angle gear is filled with
a sufficient quantity of
grease at the factory.
However, before using the
machine you should check
that the angle gear is filled
to 3/4 with grease. Use
HUSQVARNA special
grease.

Normally, the grease does
not need to be changed
except when repairs are
carried out.

Two-part shaft

The end of the drive axle in
the lower shaft should be
lubricated with grease every
30 hours. There is a risk
that the drive axle ends
(splined coupling) on two-
part shafts jam if they are
not lubricated regularly.

Maintenance schedule

Below follows some general maintenance instructions.
If you need further information please contact your service
workshop.

Daily maintenance

1.Clean the outside of the

machine.

2.Make sure the throttle

trigger lock and the
throttle function correctly
from a safety point of
view.

3.Check that the stop

switch functions.

4.Check that the cutting

head does not rotate while
idling.

5.Clean the air filter.

Replace if necessary.

6.Check that the guard is

undamaged and not
cracked. Replace the
guards if they have been
exposed to impact or are
cracked.

7.Check that the trimmer

head is undamaged and
not cracked. Replace the
trimmer head if necessary.

8.Check that the locking

nut is tight.

9.Check that all nuts and

screws are tightened.

1

2

3

4

5

6

7

8

9

Advertising
This manual is related to the following products: