Roberts Gorden VANTAGE HE HE-125 - Manual (Page 20)

HE-S ERIES I NSTALLATION , O PERATION AND S ERVICE M ANUAL
14
SECTION 6: HEATER INSTALLATION
To ensure your safety, and comply with the terms of
the warranty, all units must be installed in accor-
dance with these instructions.
The gas or the electrical supply lines must not be
used to support the heater.
Do not locate the gas or electric supply lines directly
over the path of the flue products from the heater.
The heater must be installed in a location that is
readily accessible for servicing.
The heaters must be installed in accordance with
clearances to combustibles as indicated on the rating
plate and in this instruction manual.
The minimum and maximum gas inlet pressures
must be maintained as indicated on the rating plate.
Typical installation configurations are shown in
Figure 14
.
Expansion and contraction of the tube dictates that
the minimum suspension lengths in the table on
Page 15, Figure 14
be maintained.
WARNING
Severe Injury Hazard
Burner is secured to burner
tube by bolts and
lockwashers.
Hang heater with materials
with a minimum working
load of 75 lbs (33 kg).
Failure to follow these
instructions can result in
death, injury or property
damage.