Radio Shack Audio/ Video Remote Control - Manual (Page 8)

Need help? Call 1-888-284-8735
8
AUX 2 , or PLUG ’N POWER ), then hold down P
until the red light blinks twice.
4. Enter the 4-digit code.
For example, to replace a Panasonic TV’s
remote control (set-up code 0051), press
TV ,
hold down P until the red light blinks twice, then
enter 0 0 5 1 .
When the red light blinks twice, the remote con-
trol has accepted the code.
Note: If you enter an invalid code, the red light
makes one long blink.
5. Point the 6-in-One at your device and press
POWER . Your TV should turn off.
If the remote does not operate your device, try the
other codes you wrote down in Step 1.
To Operate Your TV/VCR Combination
1. Refer to “TV/VCR Combinations” on Page 37
and write down the codes for your TV/VCR com-
bination on the supplied label.
Notes:
• Some manufacturers have several codes
listed. Try each until you find the right one.
See “Searching for a Code” on Page 48 if you
cannot find the correct code.
• Some TV/VCR combinations require a sec-
ond code to control volume. If you cannot
control volume, use one of the codes listed
for your brand in “TV/VCR Combinations.”
2. Turn on your TV/VCR combination and insert a
tape.
15-1994.fm Page 8 Tuesday, February 29, 2000 2:04 PM