Radio Shack 66 - Manual (Page 48)

48
ADDITIONAL INFORMATION
TROUBLESHOOTING
If you follow the instructions in this manual and still have trouble operating your VCR, look in this
chart for the problem description and its solution. If your VCR still does not work properly, contact
your local RadioShack store.
PROBLEM POSSIBLE SOLUTION
No power. The power cord is not connected. Plug the power cord into an AC
outlet.
Timer recording did not work,
or a broadcast was recorded
at the wrong time. The power is on. Turn off the power.
The timer is not set or is set incorrectly. Check the timer settings.
VCR Plus+ recording did not
work, or a broadcast was re-
corded at the wrong time or
on the wrong channel. The power is on. Turn off the power.
VCR Plus+ is not set or is set incorrectly. Check the VCR Plus+
settings.
The guide channels are not set correctly. Check the guide channel
settings.
Cannot record. The erase-protection tab is missing. Place a piece of tape over the
tab hole.
Picture is poor on playback. The TV is not set to the proper channel. Set the TV to the same
channel as
3-CH-4 on the back of the VCR.
The TV’s fine tuning is not set correctly. Fine tune your TV.
Audio/video connections are incorrect. Check all connections.
The playback picture is dis-
torted. The video heads are dirty. See “Cleaning the Video Heads” on
Page 51.
The VCR might not have adjusted tracking correctly. You might
need to manually adjust tracking (see “Tracking” on Page 30).
No picture on playback. The TV is not set to the proper channel. Set the TV to the same
channel as
3-CH-4 on the back of the VCR., or to its audio/video in-
put if you connected it to the VCR’s R-AUDIO-L/VIDEO OUT jacks.
Audio/video connections are incorrect. Check all connections.
Remote control buttons do
not work when the power is
on and a cassette is loaded. Something is blocking the path from the remote control to the
VCR.
16-635.fm Page 48 Wednesday, July 21, 1999 9:03 AM