Warranty, The following california air resources board – Ryobi RY52001 User Manual
Page 24
24
25
WARRANTY
RYOBI TECHNOLOGIES INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION
CONTROL SYSTEMS NON-ROAD AND SMALL OFF-ROAD ENGINES
The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Ryobi Technologies Inc. are pleased to
explain the Emission Control System Warranty on your non-road or small off-road engine. In California, new small off-road engines must be
designed, built and equipped to meet the state’s stringent anti-smog standards. In other states, new 2000 and later model year non-road
engines must be designed, built, and equipped, at the time of sale, to meet the U.S. EPA regulations for small non-road engines. The non-
road engine must be free from defects in materials and workmanship which cause it to fail to conform with U.S. EPA standards for the first
two years of engine use from the date of sale to the ultimate purchaser. Ryobi Technologies Inc. must warrant the emission control system
on your non-road or small off-road engine for the period of time listed above provided there has been no abuse, neglect, or improper main-
tenance of your non-road or small off-road engine.
Your emission control system may include parts such as the carburetor or fuel injection system, the ignition system, and the catalytic con-
verter. Also included may be hoses, belts and connectors, and other emission related assemblies.
Where a warrantable condition exists, Ryobi Technologies Inc. will repair your non-road or small off-road engine at no cost to you, including
diagnosis (if the diagnostic work is performed at an authorized dealer), parts, and labor.
MANUFACTURER’S WARRANTY COVERAGE:
The 1995 and later small off-road engines are warranted for two years in California. In other states, 1997 and later model year non-road
engines are also warranted for two years. If any emission-related part on your engine is defective, the part will be repaired or replaced by
Ryobi Technologies Inc. free of charge.
OWNER’S WARRANTY RESPONSIBILITIES
(a) As the non-road or small off-road engine owner, you are responsible for the performance of required maintenance listed in your operator’s
manual. Ryobi Technologies Inc. recommends that you retain all receipts covering maintenance on your non-road or small off-road en-
gine, but Ryobi Technologies Inc., cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all
scheduled maintenance. Any replacement part or service that is equivalent in performance and durability may be used in non-warranty
maintenance or repairs, and shall not reduce the warranty obligations of the engine manufacturer.
(b) As the non-road or small off-road engine owner, you should be aware, however, that Ryobi Technologies Inc., may deny you warranty
coverage if your non-road or small off-road engine or a part has failed due to abuse, neglect, improper maintenance, or unapproved
modifications.
(c) You are responsible for presenting your non-road or small off-road engine to a Ryobi Technologies Inc., service dealer as soon as a
problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and responsibilities, you should contact a Ryobi Technologies Inc., Customer
Representative at 1-800-860-4050.
COVERAGE:
Ryobi Technologies Inc. warrants to the ultimate purchaser and each subsequent purchaser that your non-road or small off-road engine will
be designed, built, and equipped, at the time of sale, to meet all applicable regulations. Ryobi Technologies Inc. also warrants to the initial
purchaser and each subsequent purchaser that your non-road or small off-road engine is free from defects in materials and workmanship
which cause the engine to fail to conform with applicable regulations for a period of two years. The 1995 and later small off road engines are
warranted for two years in California. In all other states for 1997 and later model years, EPA requires manufacturers to warrant non-road en-
gines for two years. These warranty periods will begin on the date the non-road or small off-road engine is purchased by the initial purchaser.
If any emission-related part on your engine is defective, the part will be replaced by Ryobi Technologies Inc. at no cost to the owner.
Ryobi Technologies Inc. shall remedy warranty defects at any authorized Ryobi Technologies Inc. engine dealer or warranty station. Any
authorized work done at an authorized dealer or warranty station shall be free of charge to the owner if such work determines that a war-
ranted part is defective. Any manufacturer-approved or equivalent replacement part may be used for any warranty maintenance or repairs
on emission-related parts, and must be provided free of charge to the owner if the part is still under warranty. Ryobi Technologies Inc. is
liable for damages to other engine components caused by the failure of a warranted part still under warranty.
The California Air Resources Board’s Emission Warranty Parts List specifically defines the emission-related warranted parts. (EPA’s regula-
tions do not include a parts list, but EPA considers emission-related warranted parts to include all the parts listed below.)
These warranted parts are: Carburetor, Spark Plug, Ignition, Air Filter, and Fuel Filter.
MAINTENANCE REQUIREMENTS
The owner is responsible for the performance of the required maintenance as defined by Ryobi Technologies Inc. in the operator’s manu-
al.
LIMITATIONS
The Emission Control Systems Warranty shall not cover any of the following:
(a) repair or replacement required because of misuse or neglect, lack of required maintenance, repairs improperly performed or replace-
ments not conforming to Ryobi Technologies Inc. specifications that adversely affect performance and/or durability, and alterations or
modifications not recommended or approved in writing by Ryobi Technologies Inc., and
(b) replacement of parts and other services and adjustments necessary for required maintenance at and after the first scheduled replacement
point.
The Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which the
engine has been shown to meet Federal emission requirements. Category C=50 hours, B=125 hours, and A=300 hours.
THE FOLLOWING CALIFORNIA AIR RESOURCES BOARD
(CARB) STATEMENT ONLY APPLIES
TO MODEL NUMBERS REQUIRED TO MEET THE CARB REQUIREMENTS.