Radio Shack 15-2130 - Manual (Page 10)

Remote Control
9 Manual Code Search
MANUAL CODE SEARCH
If the Guide Remote* does not operate your device, when set up, you may not
have entered the correct 4-digit code. You may manually search for codes in each
device category to locate one that operates your brand of device. See page 26 for
list of Manufacturer’s codes. To manually search for a codes that works on your
device perform the following steps.
1. Press device key (TV, VCR, CBL/SAT or DVD). The red light blinks one
time.
2. Press the P key. The red light blinks two times.
3. Press the 0 0 0 0 digit keys. The red light blinks one time.
4. Press the P key. The red light blinks three times.
5. Press any IR key (POWER, CH+, CH-, VOL+, VOL-, etc.). The red light
blinks one time for each key pressed.
6. If the device operates the desired function, press the device key (TV,
VCR, CBL/SAT or DVD to exit and save the code. The red light blinks
one time.
7. If the device does not operate the desired function, press the P key then
the desired IR key(s), (POWER, CH+, CH-, VOL+, VOL-, etc.) again.
Repeat the process until you find a code that operates your device.
8. Once you find a code that works press the device key (TV, VCR,
CBL/SATor DVD) to exit and save the code.
AUTO CODE SEARCH
The remote can perform an auto-search to locate a code that operates your
devices. To allow the remote to perform an auto-search for a code perform the
following steps.
1. Press the desired device key (TV, VCR, CBL/SAT or DVD) on which to
perform a code search. The red light blinks one time.
2. Press the P key. The red light blinks two times.
3. Press the 7 digit key. The red light blinks one time.
4. Press the P key. The red light blinks three times.
5. At 2.5-second intervals, the remote will send POWER key commands. If the
device does not have a power code, the remote will send the following
commands in order, PLAY, CH+ and MUTE IR. If none of these commands
exists for the device, the device is skipped.
6. Press the device key (TV, VCR, CBL/SAT or DVD) to stop auto-search and
save the code. Press any other key except device key to terminate the
search without saving a code.
The P key is ignored if pressed to terminate
auto search.
Note: It may take up to several minutes to locate a code that operates the device.