Radio Shack 15-2130 - Manual (Page 20)

Remote Control
19 Backlight / Factory Reset
BACKLIGHT
• Press the LIGHT key to turn on the backlight. When the LIGHT key is
pressed, the backlight is preset to stay on for 5 seconds.
• Each time any key is pressed, the 5 second timeout is reset. If no key is
pressed for 5 seconds, the backlight will turn off.
• If the LIGHT key is pressed while the backlight is on, it will turn off.
The backlight on your remote can be set to turn on and stay on for up to 10
seconds. To change the backlight setting to a 10-second timeout perform the
following steps:
1. Press any device key (TV, VCR, CBL/SAT or DVD). The red light blinks 1 time.
2. Press the P key. The red light blinks 2 times.
3. Press the number 9 digit key. The red light blinks 1 time.
4. Press the P key. The red light blinks 2 times. The backlight will now remain on
for up to 10 seconds after the last key is pressed.
Repeat steps 1-4 to change the backlight setting back to a 5 second timeout. The
red light blinks 1 time in step four to indicate a 5 second backlight timeout.
FACTORY RESET
The Guide Remote* can be reset to the factory default settings. Once reset, all macros
and setup devices revert to default settings and devices. To reset remote to factory
settings, perform the following steps.
1. Press any device key. The red light blinks 1 time.
2. Press the P key. The red light blinks 2 times.
3. Press the number 8 digit key. The red light blinks 1 time.
4. Press and hold the P key for 3 seconds. The red light blinks 2 times.