Radio Shack 15-2130 - Manual (Page 11)

Remote Control
View Device Codes 10
VIEW DEVICE CODES
To determine the 4-digit code for each device set up in your remote perform the following
steps:
VIEWING CODES
1. Press the desired device key (TV, VCR, CBL/SAT or DVD). The red light blinks
one time.
2. Press P key. The red light blinks two times.
3. Press number 1 digit key. Press P key. Count the blinks (for example, if the red
light blinks five times the first digit in the code is 5). Write down the number.
Note: The red light will not blink if the digit in the code is the number 0.
4. Press number 2 digit key. Press P key. Count the blinks. Write down the number.
5. Press number 3 digit key. Press P key. Count the blinks. Write down the number.
6. Press number 4 digit key. Press P key. Count the blinks. Write down the number.
You can re-verify the number of blinks to identify either the first, second, third or fourth
digit in the code by repeating any of the above steps.
Press any device key (TV, VCR, CBL/SAT or DVD) to exit this mode. The remote
automatically exits this mode after 20 seconds of inactivity.
REASSIGNING DEVICE KEYS
You can reassign a device key (TV, VCR, CBL/SAT or DVD) to control any type device.
For example, the VCR key can be set up to control a second TV, or the DVD key can be
set up to control a second VCR.
Note: You must use the device category assigned to the key to perform an Auto Search
and Manual Search.