Radio Shack ET-007 - Manual (Page 11)

11
SETTING THE DIALING
MODE
Set TONE/PULSE on the bottom of the
corded phone for the type of service you
have, either tone or pulse (rotary). If you
are not sure which type you have, do
this simple test.
1. Set TONE/PULSE to TONE .
2. Lift the handset and listen for a dial
tone.
3. Press any number except 0 and 1.
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code either.
If the dial tone stops, you have
touch-tone service. If the dial tone
continues, you have pulse service.
4. If you have pulse service, set TONE/
PULSE to PULSE .
CHANGING THE RINGER
TONE
There are four different ringer tones you
can choose or you can turn off the ring-
er. The ringer system is separate for the
corded phone and wireless headset.
Follow these steps to change the ringer
tone:
1. Make sure the phone is on-hook.
Press PROGRAM on the base.
2. Press # , then 1 for the base ringer
tone, or 2 for the headset ringer
tone.
3. Press 1 , 2 , 3 or 4 . You hear the cor-
responding ringer tone. To turn off
the headset’s ringer, press
0 .
4. Press PROGRAM to select the
desired ringer tone. A confirmation
ring sounds, indicating that you suc-
cessfully set the desired ringer tone.
F LOW-HIGH
TONE PULSE
PROGRAM
43-007.fm Page 11 Wednesday, March 22, 2000 11:24 AM