Radio Shack ET-007 - Manual (Page 15)

15
To switch from the headset to the hand-
set, press
HOLD on the infrared remote
dial card. The IN USE/BATT. LOW indi-
cator flashes. Pick up the handset to an-
swer the call. The headset sounds a
tone if the handset is not picked up with-
in about 30 seconds.
Using the Intercom
To use the intercom to switch from the
handset to the headset, press
HOLD
then INTERCOM on the base. The head-
set rings. Press INTERCOM on the re-
mote dial card. You can talk to the
person on the handset. To transfer the
call to the headset, press
PHONE/
FLASH , then place the handset on the
cradle.
To use the intercom to switch from the
headset to the handset, press
HOLD
then INTERCOM on the remote dial card.
When the corded phone rings, pick up
the handset. You can talk to the person
on the headset. To transfer the call to
the handset, press
INTERCOM then
HOLD on the base.
Notes:
• If you are using the handset and you
press INTERCOM during a call, the
call cannot be transferred to the
headset. The call is disconnected,
the headset rings, and you can use
the intercom.
• If you are using the headset during a
call, press INTERCOM on the remote
dial card to mute the microphone. To
resume the call, press
INTERCOM
on the remote dial card or pick up
the handset to continue the call. To
end the call, press
OFF on the
remote dial card, pull the micro-
phone up until it clicks, or put the
headset on the charger.
SETTING THE HANDSET
AND HEADSET VOLUME
To control the handset volume, slide the
switch on the side of the handset (
Low ,
Med , Hi ) to adjust to a comfortable listen-
ing level.
To select one of the headset’s 8 volume
listening levels while using the headset,
press the
VOL or on the side of
the headset, or press VOLUME or
on the infrared remote dial card.
Low/Med/Hi
VO L
43-007.fm Page 15 Wednesday, March 22, 2000 11:24 AM