Radio Shack ET-007 - Manual (Page 6)

6
INSTALLATION
SELECTING A LOCATION
You can place the ET-007 on a desk or
table, mount it on a standard wall plate,
or mount it directly on a wall. Choose a
location that is:
• near an AC outlet
• near a modular telephone line jack
• out of the way of normal activities
Note: Your ET-007 connects directly to
a modular telephone line jack. If your
phone line jack is not a modular jack,
you can update the wiring yourself, us-
ing jacks and adapters available at your
local RadioShack store. Or, you can let
the phone company update the wiring
for you.
Cautions:
You must use a Class 2
power source that supplies
9V DC and delivers at least
300 mA. Its center tip must be set to
positive and its plug must fit the ET-
007's
9V DC 300mA jack. The sup-
plied adapter meets these specifica-
tions. Using an adapter that does
not meet these specifications could
damage the ET-007 or the adapter.
• Always connect the AC adapter to
the ET-007 before you connect it to
AC power. When you finish, discon-
nect the adapter from AC power be-
fore you disconnect it from the ET-
007.
CONNECTING THE
HANDSET
Plug the supplied coiled handset cord
into the jacks on the handset and the left
side of the corded phone.
Note: Your local RadioShack store sells
a variety of longer coiled handset cords,
which are especially useful when you
mount the phone on the wall.
PLACING THE BASE
TELEPHONE ON A DESK
1. Plug one end of the supplied modu-
lar cord into the TEL. LINE jack on
the back of the base.
2. Plug the modular cord's other end
into a modular phone line jack.
3. Plug the supplied AC adapter's bar-
rel plug into the 9V DC 300mA on the
back of the phone. Then plug the
adapter into a standard AC outlet.
!
300mA
43-007.fm Page 6 Wednesday, March 22, 2000 11:24 AM