Radio Shack CENTRAL 49-2570 - Manual (Page 11)

11
ASSIGNING SECURITY
ZONES
A security zone is an area of protection
covered by a single door/window sen-
sor transmitter, motion detector, or oth-
er sensing/transmitting device. Your
security console monitors up to 16
zones and alerts you if there is a viola-
tion (see “Zone Indicators”).
When you initialize your security sys-
tem’s sensor transmitters, the console
assigns a zone number to the sensor
transmitter (see “Initializing the Door/
Window Sensor Transmitters”). The kit
includes numbered stickers you attach
to each sensor transmitter to show its
zone number.
For your reference, make a record of
which area of your home a zone cov-
ers. For example, using the floorplan
you drew, you could mark the front
door as “Zone 1.”
REASSIGNING
SECURITY ZONES
If you want to remove one accessory,
reassign an accessory to a zone cur-
rently in use, or add an accessory
when all zones are assigned, you must
completely reinitialize the system.
To reinitialize the system, set INSTALL/
RUN 1/RUN 2 to INSTALL . Then press
PANIC , ARM HOME , and ARM AWAY on
the console at the same time. Reinitial-
ize all remote controls, door/window
sensor transmitters, and motion detec-
tors, assigning each accessory to the
desired zone.
49-2570.fm Page 11 Wednesday, August 18, 1999 3:59 PM