Radio Shack CENTRAL 49-2570 User Manual
Page 31
31
Problem
Solution
The red indicator on the sen-
sor transmitter/motion detec-
tor stays on during installation.
Remove then reinstall the sensor transmitter/motion de-
tector’s batteries. Press
TEST
again.
The ARMED indicator is flash-
ing.
This indicates that there has been an intrusion. Also, if a
zone indicator is on, this indicates which zone was violat-
ed. To turn the zone indicator off and stop the armed in-
dicator from flashing, press the
ARM
or
DISARM
button on
a remote control. If a zone indicator is not on, the violated
zone is within Zones 9-16. Press
ZONES 9-16
on the con-
sole to see which zone was tripped.
A motion detector causes
false
alarms
.
• Motion detectors sense motion by detecting a
change in temperature; therefore, do not place the
motion detector near an air conditioning or heating
vent.
• Do not place it in a direct source of bright light, such
as sunlight.
• It could be detecting a pet’s movements. Set the
switch on the back to
2
so it is less sensitive or
cover its bottom zones.
49-2570.fm Page 31 Wednesday, August 18, 1999 3:59 PM