RedMax HE2601 - Manual (Page 12)

Operation
5. While pulling the throttle trigger with the
little finger of your left hand, pull the starter
rope.
• Avoid pulling the rope to its end or returning
it by releasing the knob. Such actions can
cause starter failures.
6. When the engine has started, move the
choke lever gradually downward to open
the choke.
7. Allow the engine to warm up for a half
minute before starting operation.
1. When restarting the engine immediately
after stopping it, leave the choke open.
2. Overchoking can make the engine hard to
start due to excess fuel. When the engine
failed to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.
NOTE
NOTE
■ STOPPING ENGINE
1.Release the throttle trigger and run the
engine for a half minute.
2.Shift the ignition switch to the STOP
position.
• Except for an emergency, avoid stopping
the engine with the trigger pulled on.
■ ADJUSTING IDLING SPEED
1. When the engine tends to stop frequently
at idling mode, turn the adjusting screw
clock-wise.
2. When the cutting head keeps rotating after
releasing the trigger, turn the adjusting
screw counter-clockwise.
1. After setting up the unit, check play of the
throttle cable. The normal play is between
.04" and .08" (1mm and 2mm).
2. Warm up the engine before adjusting the
idling speed.
NOTE
NOTE
❲ 10 ❳