RedMax HE2601 - Manual (Page 9)

Set up
1.Insert the shaft tube into the clutch
housing, then align the positioning holes
and screw in the lock screw. Tighten the
clamp bolts.
2.Insert the driveshaft into the clutch drum,
then attach the gearbox to the shaft tube
as aligning the positioning holes. Wipe out
grease on the tube and the inside of the
gearbox. Screw in the lock screw and
fasten the clamp bolt firmly.
3.Install the blade guard to the gear case
with the provided 3 screws, then clamp it
to the shaft tube with 2 screws.
4.Place the blade between the cutter holders
(A) and (B) while locking the gear shaft by
putting the bar, one of the tools provided,
through the key holes on the holder(A)
and the gearcase. Use the socket and the
screwdriver as shown in the picture below
to tighten the blade mounting bolt.
5.Split the bracket and install the wheel
assembly to the shaft tube and clamp at a
position best for your job.
6.Install the J-shaped handle to the shaft
tube and clamp at a position best for your
job.
7.Open the air cleaner cover and connect
the throttle cable to the carburetor. Put on
the cap to the joint to secure the
connection.
8.Connect the switch wires between the
engine and the main unit. Pair the wires of
the same color.
❲ 7 ❳