RedMax HE2601 - Manual (Page 13)

How to use
1. A l w a y s wear eye protection such as
safety goggles. Never lean over the
rotating cutting head. Rocks or other
debris could be thrown into eyes and
face and cause serious personal injury.
2. Keep the blade guard and the mad
guard attached in place at all times
when the unit is operated.
3. Before starting a job, check the area
and remove all obstacles and objects
that could be thrown by the blade.
4. Do not adjust the wheel height or try to
remove anything entangled to the blade
with the engine running.
WARNING
1. Before starting the engine, adjust the
wheel height for desired cutting depth(See
page 9).
2. Before starting a job, plan your direction of
travel so that you can always hold the
edger on you right side and can walk on a
hard surface as much as possible.
3. When starting to edge, run the engine at
full throttle, and slowly have the blade cut
into the edge groove.
• Do not use the HE2601 to make a new
groove into the ground. Such usage will
not be covered by RedMax Warranty.
NOTE
❲ 11 ❳